Finally decided to make some 44 on my WH, but didn't like it that the press sat so low. Also, needed to have it overhang my bench by a bit so the handle could have a full stroke. My not-so-elaborate solution was to use an Inline Fabrication base & a couple pieces of 1/2" aluminum I had. I normally use these for my RC swaging presses for 22 & 6mm swaging, so the presses can lay horizontally. Finally broke down & drilled holes in the bench for mounting too, clamps weren't gonna cut it with this much mass. The plates are probably way overkill, but I've heard tell that overkill ALWAYS works, so what the hell.........
Mark