MidSouth Shooters SupplyTitan ReloadingRotoMetals2Inline Fabrication
Graf & SonsADvertise hereStainLess Steel MediaLee Precision

Results 1 to 2 of 2

Thread: Working on loads with the Remington #4 Rolling Block

  1. #1
    Boolit Master
    Join Date
    Mar 2011
    Posts
    407

    Working on loads with the Remington #4-Another trip to the rangeRolling Block

    I have been tinkering with the Remington Rolling Block #4 in .32 rimfire using the Dixie Gun Works cases. I loaded up three more rounds, filed down a flat spot on three .310" round balls and weighed them all out at 42 grains. The loads were also measure a bit more.

    I went back to the range and tried them out, the first round didn't get good ignition, you could tell from the sound it wasn't as good as it should be, ended up to the left and low of the target. The next two went off without a hitch and pulled a decent group. I am going to try to get to the range tomorrow to try it again with three more and some more powder and lead balls to reload it again.

    I found some .315" heeled bullets that will work for this round and hope to get them here pretty soon, my goal is to take this gun out squirrel hunting at least once.

    This was at 25 yards.



    This was the last outing at 25 yards.



    I took the Remington out again today. Same thing, three .310" roundballs filed down on one side to seal it against the powder and then weighed out so that all three roundballs are at the 42 grain mark. The cases are primed with the .22 cases and then the blackpowder charges are weighed out, about 8 grains of FFG for these cases after the powder is in, the roundball is seated and then they're ready to go.

    I think next week I am going to take this gun squirrel hunting.



    Last edited by David LaPell; 12-07-2017 at 12:09 PM.
    No people in the world ever did achieve their freedom by goody-goody talk and moral suasion: it being immutable law that all revolutions that will succeed must being in blood, whatever may answer afterward.

    Mark Twain

  2. #2
    Boolit Master

    Wayne Smith's Avatar
    Join Date
    Mar 2005
    Location
    Hampton Roads, Virginia
    Posts
    9,655
    Are you familiar with Bernie at Old West Bullet Molds. He is the go to guy for heeled boolit molds and modified Lee crimp dies to crimp the heeled boolit.
    Wayne the Shrink

    There is no 'right' that requires me to work for you or you to work for me!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check