"You believe these people exist to provide you with position, I believe your position exists to provide these people with FREEDOM"
FREEEEEEEEDOMM-William Wallace
Nice group, I would be thrilled if mine shot like that
"You believe these people exist to provide you with position, I believe your position exists to provide these people with FREEDOM"
FREEEEEEEEDOMM-William Wallace
1680 should work. Problem is seating depth. See how much powder will fit in case, check sub loads to insure load is safe. If an AR I'd back off the bore a bit. Don't know if it will cycle ok. Or find a different mould.
Whatever!
I'd think that you could get a nose sizing die from NOE so that you could seat the bullet further out, assuming the magazine will accomodate it.
USMC 6638
I use that bullet in my .30-30 single shot. Best bullet I've found so far.
I'm surprised they only weigh 160gr. I use the 160gr 2R TL powder coated. Mine weigh between 166 and 168 grains depending on if they are gas checked or not. I haven't tried them super sonic yet from the BO only non cycling sub-sonic.
Here are some with gas checks. I don't have any photos with them loaded in the BO yet but can post a OAL if needed.
Motor
Motor, I don't believe those a 311466 bullets in your photo.
They aren't. The 466 is a Loverin design.
I decided to go for it and loaded up a few. The group pictured was with 7.0g of Blue Dot. They did not cycle my carbine gas system which I figured would be the case. They are slow and pretty quiet. It made me laugh a little to hear the gun go off, then hear it smack the target at 50 yards and then hit the berm. I think I will load them again but probably try to get them to cycle next time.
"You believe these people exist to provide you with position, I believe your position exists to provide these people with FREEDOM"
FREEEEEEEEDOMM-William Wallace
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |