So I’m reloading on a Dillon 650 with Dillon dies. I’m finding that I’m getting some swaging of 0.001 from the brass. I’ve done a lot of reading here and all advice point to 1) not using the Lee Factory Crimp die, which doesn’t apply, or 2) use a Lyman M die. I’d rather not loose my powder check station by adding the M die, and I’d like to retain my powder through. So my search found the Mr Bullet feeder Dillon Powder funnel which some claim is like the M-die. https://www.midwayusa.com/product/51...-powder-funnel

I found a single old thread here from two years ago that was inconclusive. Can anyone confirm this is a good option for me to fix my swaging in my Dillon?

Merry Christmas everyone!