As ya'll know i'm new at these auto caster's ( Ballisticaster II, used ) it has ballisticcaster moulds in it ,,but the cam's were so tight I could just "bearly" turn it by hand,,book said this was to tight,,so adj. outside (4) bolt's until I could turn it easier,,now the mould's have a slight gap,, at the top ( when it pour's),,. how tight are the "key's" in the mould's suppose to be,,if I tighten the cam's up to close the gap's,,it get's to tight . Are we suppose to shim the "key's",or do they need some movement? Am I making any sense,,?
Later,,,,Hootmix.