Hello all,
my 1903 was drilled and tapped for a Lyman or other receiver sight at some point in its past. The rifle does have a rear sight on it but was missing the windage adjustment screw which I added, perhaps incorrectly. I shoot cast boolits only in the rifle and is quite accurate with "The Load" for the first couple shots then wanders to the right.
It is a repeatable occurrence. I would like to add a receiver sight to the rifle but am unsure which one to put on it. the holes seem to be drilled off center from one another. and are spaced 0.600 apart or 5/8" ctc. one hole being lower than the other. trying to figure out which sight would work.
see pic if it loads. will not load picture.
any help would be appreciated.