so a lot of you know I have been saving for a 9.3X62 CZ. I have a lee classic cast O-frame style press. I was looking through the lee 2nd edition at some shells for jackets. the two that stuck out were the .223 and 38spl. the 223 rim and shell base diameter is .378, so if I got 2 lee sizer kits, one in the middle and a .365 (needs to be .366, but I figure there will be some rebound), would that be doable with my press? and as far as dies, I would need a nose die, but how do you eject the bullet after you form the nose? as far as the 38, it seems like I could size it in one go, but only if I had someone lathe turn the rims down to .366. so what would you do, and as far as dies, how simple and cheap could I get away with? I want to make softpoints, either flat tipped or a fairly blunt round nose. thanks a lot, hope someone knows of a simple and inexpensive way of accomplishing this! thanks-Travis