i finally made me a die to make .323 bullets for my Hakim and 8mm Mauser.. finished up the reamer today and went ahead and made the die and heat treated it.. i used a die that did not turn out like it should have for the .308 so i was not wasting anything, i just annealed the die and reamed it and rehardened it and polished it. i should be able to get upwards of 200gr bullets with it.. now i just got to make 2 other dies and a new core mold to fit it. just need a core seating die and a new trimmer die.. i think ill make the new trim die adjustable with the lower pin so i can get any length jacket i want..
the bullet shown was a test bullet to see how it swaged. this is a 150gr flat base open tip. it didn't turn out as pretty as it could have being i was swaging up the .308-.311 jackets and cores but it did ok..