As the tilte says I am getting out of casting and selling everything in one lot. Price is $2,500.00 for everything listed below. Will not separate or ship. All items located in Murphy, TX (NE of Dallas)
All lead is cast in Lyman 1lb ingot molds. Most ingots are over a pound and all were processed for my use so there is not any zinc.
70 ingots blended ready to cast.
775 ingots COWW
208 ingots linotype (Edited for quantity)
601 ingots SOWW
65 ingots range scrap
108 ingots food grade pewter (10oz) (Edited due to incorrect quantity)
Lyman Mag 25 furnace
Lee 4-20 furnace
7 Lyman 4 cavity ingot molds
Satan's smelter 40lb
8lbs powder coating paint
Sears powder coating gun
Lee 358-158 GC 2 cavity mold
Lee 452-230 TC 2 cavity mold
Lee 356-102 RN 2 cavity mold
Lee 401-175 TC 2 cavity mold
Lee 452-300 GC 2 cavity mold
Lee 309-170 GC 2 cavity mold
Lee 225-55 GC 2 cavity mold
Lee 452-230 TC 6 cavity mold
Lee 401-175 TC 6 cavity mold
Lee 356-125 RN 6 cavity mold
Lee 452-228 RN 6 cavity mold
Lee 358-158 SWC 6 cavity mold
Lee 356-124 TC 6 cavity mold
Lee C frame press
Lee bullet feeder with 9, 45, 40 fingers
Lee .356 sizing die
Lee .401 sizing die
Lee .358 sizing die
Lee .452 sizing die
Lee .225 sizing die
Lee .309 sizing die
Lee .454 sizing die
Hornady 22 cal gas checks unopened box
Hornady 45 cal gas checks open box less than 100 used
Hornady 35 cal gas checks open box less than 200 used
Hornady 30 cal gas checks open box less than 100 used
Black and Decker oven for powder coating with Auberins PID controller.
So that everyone understands why I changed the quantities when I was making my list is had the amount of ingots on the right and the value on the left on a piece of paper. When I created the listing I went off of the wrong side. It was my mistake but was not intentional.