While I was doing my research before loading I found this for ya. It is with a different powder than RDot (WIN 231), but you can likely use the info since the powder used was on your list in the OP.:
http://castboolits.gunloads.com/show...l=1#post706842
Here is the topic from the top:
http://castboolits.gunloads.com/show...boolits-in-9mm
Some of the things I am checking on before I load any rounds will be OAL, & feed for both the 147WC & the SWC158. I have been thinking about this since yesterday. If I can not get the WC to feed after setting it out so I do not compress the load, I think I will take a file & remove some of the tip of the 158 gr. SWC to bring it down to 147gr. & see if that feeds.
I have some 124gr. 2Rs that I have been using & I think I may just seat the 147 or 158 to the same depth into the case as the 124gr & check OAL to make sure it is not over the Max OAL and go with that, then check for feed & plunk. That way it will not be taking up any more case room than the 124gr. and cause an overpressure from that.
Once I get the OAL & Feed taken care of, then I will be figuring out the loads for the ladder testing of each. Then, as I test the loads when I fire, I will be looking for cycling issues & overpressure issues as I go up in powder amounts. At the same time observing the FPS from the chrony as I go. I will not be looking for accuracy at this point, just finding the "window" for the loads. I am still researching the loads, & have found some to use both in the manuals & online. I will be starting relatively low for reduced loads & safety reasons first, then move up to approach the start loads I have found and keep an eye on possible issues.
I will repeat that I am using a Ruger SR9 for this & it is relatively new. With only 3-400 rounds thru it, so it should be up to the task & basically just broken in. Feeding issues may not be the same for your 9mm, & of course are dependent on the boolits tip as well. ( I am pretty sure the WC is gonna be a "no go" because of the flatness, but I will try it with a dummy or two a few times to see if I can make it work anyway, otherwise, I will file down the 158SWCs to 147 & try those too.)
My main goal right now is finding the reduced loads below "book" start loads up to a point that is still below max & cycles the firearm well.( <should be in the lower 2grs, then go up) Then work back down or up again from the bottom (reduced start) for accuracy "sweet spot(s)".
Well, that is all I am up to for ya at this point with the Red Dot testing. I will be doing more tomorrow & hopefully shooting by Friday.
If I run across any more loads or data for the other powders as I go, I will bring them here for ya.
I hope I am not overwhelming your topic here with my posts, I just want to share what I am doing & what I find to help. Both you & me, plus possibly others who come along later. But, if ya want me to back off, I certainly can. Just let me know.