Wts: dillon 650xl

[sparky45]

Going to sell my Dillon since I haven't used it in over a year. I have 4 other presses and don't shoot as much as I once did.

Dillon xl650 reloading press

xl650 press
case feeder with (3) plates – lg & sm pistol + sm rifle
extra complete primer assembly (one set for small and one set for large)
extra toolheads - total of (3)
extra powder measure - total of (2) complete measures
press cover
extra parts kit
dillon strong mount
aluminum roller handle
bullet tray
powder check
roller cam follower
roller bearings on top of the shell plate
phenolic bearing under the shell plate to negate shell plate "slap" when indexed
empty Case Bin & Bracket (installed)
priced @ $1400 and I prefer local pickup to give the buyer the opportunity to see the press actually working. If shipped, it's on your dime.

Located one more caliber conversion kit (380) and a Mr. Bulletfeeder Die. I will let these go to the buyer of the 650 for a markedly reduced price.

[sparky45]

Addendum:

Forgot to list the Caliber Conversion Kits; (4) that are also included.

[5Shot]

If you decide to break up any of the Case Feeder Plates, Primer Assy and Caliber Conversion Kits, I would be interested.

[sparky45]

Thanks for the offer, but it's a set.
BTW, the caliber conversion Kits are:
9mm
38/357
45acp
.223

[SSGOldfart]

I could use a complete power measure. Good deal just bad timing on my part...

[sparky45]

Attachment 206179Attachment 206180Attachment 206181

[CraigOK]

Where are you at in se ks?

[sparky45]

I used to work in Bartlesville; retired from Anesthesia @ JPMC. I live in Sedan, about 35-40 minutes from you.

[RyanStunT]

Hello Sparky, i am interested and sent you and email.
Thanks
Ryan

[huntnman]

subscribed and looking.

[sparky45]

Never received an email Ryan.

[RyanStunT]

Hello Sparky,
I tried to send it through the forum, can you email me ryanstunt@hotmail.com

Thanks
Ryan

[sparky45]

Hey Ryan; where are you located?

[BradInTexad]

How do you like the roller handle?

[sparky45]

I wouldn't use it without the roller handle; greatly increases the effectiveness of the press IMO.

[Littlewolf]

shame i already have all but the 223 in dillon presses if i had 1400 pounds of lead gathered and smelted id trade that for this lot set

[BradInTexad]

It looks like it would be helpful. Thanks.

[sparky45]

Thanks for the reply; All PM's answered.

[sparky45]

One more time.

[sparky45]

OK; again to the top.