Deleted
Deleted
Last edited by Phineas Bluster; 01-29-2020 at 11:12 PM.
that's the same answer I would have given you.
a screw isn't that big a deal but not being able to get a hammer or mainspring is.
if I had a way to measure a screw or it's thread pitch I could go pull one out but I got no way to do that.
I am not familiar with the USFA Gunslinger. However on the earlier U.S.Ptd.F.A., current Uberti parts will interchange. Perhaps some parts of the later revolvers we not US made, but they continued to use Uberti parts. I know the later frames, cylinders and barrels were made in the USA, I don't know about such non-critical parts like the ejector housing, screw and spring.
Disclaimer: The above is not holy writ. It is just my opinion based on my experience and knowledge. Your mileage may vary.
I was thinking numrich gunparts.com
kids that hunt and fish dont mug old ladies
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |