WTK who makes a good 30 cal pistol mold

[dogmower]

just got into the 7.62 x 25 pistol with a Yugo tok and a cz52. like them both, but don't have a good mold to cast with. any advice/experience welcome
thanks guys.

[HABCAN]

We've used the LEE 6-cav '93' with success in that cartridge, PC'd.

[Dan Cash]

Accurate molds has a sack full of molds suitable for the 7.62x25. I use this one http://www.accuratemolds.com/bullet_...=31-105C-D.png sized to .311 for the 7.62 Mauser with the same amm going into my CZ52. Also use the bullet in .32-20 revolver and rifle. The gas check is not needed. Keep the bullets relatively soft and Unique or Bulls Eye will get you 1200 -1400 fps or so with no leading.

[Outpost75]

I use Accurate 31-087B and 31-100T in my TT33 and CZ52 pistols.

Attachment 205390Attachment 205391

Attachment 205392

Velocity Test Data for 7.62x25 in TT3 Pistol

Handloads in Starline cases with CCI500 primers

Ammunition Description___________Vel@15ft., Sd, ES n=10
_________________________________TT33, 4.6”
Romanian P Ball, Factory 22, 1984____1461 fps, 27 Sd, 76ES
Yugoslav PPU Ball,_________________1310, 26 Sd, 66ES
Hdy 86-grain JSP, 7.4 grs. AutoComp__1353, 20, 71
Accurate 31-100T, 7.4 grs. AutoComp__1450, 16, 50
Accurate 31-087B, 5.3 grs. Bullseye___1433, 28, 71
Accurate 31-087B, 10.8 grs. #2400___1321, 11, 32
Nor. 93FMJ .307”, 10.8 grs. #2400___1277, 18, 44

[rintinglen]

I have a saeco 321 4 cavity that I have used for this cartridge. It is a nominal 95 grain RN that fed well from a Norinco type 54 I used to have.