I'm "restoring" a CH Swag-O-Matic for the fun of it. It's more of a nostalgia trip than anything because I really don't use any jacketed bullets in any of my handguns. I want to, I can, ergo I am.
Not quite up to Descartes but as close as I'm going to get.
If someone out there has a set of Swag-O-Matic dies handy and you have the time to measure them, I would appreciate the dimensions for the following parts:
1. OAL of the ejector rod. I assume the head diameter is indicated by the caliber being swaged and the stem diameter by the hole in the hardened washer.
2. Nose punch large diameter and length
3. The length and OD of the floating spacer
From the crappy copy of instructions I found on the internet I understand that the bolt that holds the nose punch in place is pretty much just a standard 5/16" x18 bolt. Is that a correct assumption?
Thank you in advance for any information you can give me.