.308 cast load data

[donovansn585]

I just recently acquired a savage model 11 .308 and I plan on shooting a lot of cast boolits out of it looking for some first hand advice of peoples favorite cast loads. I am going to be using the lee 312-160r mold tumble lubed and gas checked to .309. The powders I have available are imr4895, h4198, cfe223, tac, imr4198, blue dot which I know is mostly for reduced loads not really a choice but I figured I would throw it out there. So please let me know any loads you really like using the powders I have available to me please. Thank you everyone very much.

[Kraschenbirn]

Why reinvent the wheel? There are already at least two current threads on this very topic and scads of information/data in the 'stickies' and archives.

Bill

[donovansn585]

Ok thank you I will search for them have not had a lot of luck using the search feature

[10mmShooter]

Donovan

check this thread although discussion is for a gas gun it will get you some good info.

http://castboolits.gunloads.com/show...pringfield-M1A

[Nrut]

donovansn585,

Try this link for searching the forum..
Way better:
https://www.google.com/cse/home?cx=0...69:ggn3vg-bjum

I haven't shot grease groove bullets out of my 308's so I can't help you there..
One thing though I am betting that your bullet sized to .309" is going to be to small..
If you are serious about shooting cast then you should make a "impact slug or pound slug" of your throat area so that you will know the exact size to size your bullet..
There is a sticky above by goodsteel that explain's how to do it..

[Randy C]

That is a good search engine I've never tied that one thanks.

[runfiverun]

one of the most accurate loads I have ever shot has been 28 grs of 4895 and a filler using a fairly soft brisance large rifle primer like the federal 210.
[boolit weights from 150 to 180 grs ]
I got away from using the load because it was ridiculously boring.

[waco]

Attachment 96646

I'm trying to get this one going in my .308

NOE 311365 198gr

Rem. 700 heavy barrel, 1:10 twist

Alloy runs around 32BNH

Shooting for somewhere near 2200fps @ around 40-42K PSI

[exile]

Attachment 96646

I'm trying to get this one going in my .308

NOE 311365 198gr

Rem. 700 heavy barrel, 1:10 twist

Alloy runs around 32BNH

Shooting for somewhere near 2200fps @ around 40-42K PSI

Thinking about buying a Savage .308 myself, but from what I am reading hear on castboolts, a .309 sizer is too small, I maybe need a .311 sizer? Has Lee discontinued those? Also which Lee factory crimp die will work with a .311 sizer in .308 cases? I have a Lee 160 grain mold for 7.62 x 39 boolit, will these be too light for a 1 in 10 twist .308 barrel? Have not shot cast in a rifle yet, hope these are not dumb questions. Thanks, exile