Not gun related at all, but some of you guys will know the proper way to make small holes bigger. lol
I have been drilling a 3/8" pilot hole then using a 5/8 reamer to get my 5/8" holes that I needed. I have been doing the same then stepping up to the 3/4 reamer for the 3/4" holes I needed.
I got them done, but on each and every 3/4" hole my old black and decker drill put a beat down on me, but I won in the end sorta.lol
Step it up to the one inch holes. I had planned on doing the same then switching to a 1" reamer. All of these are accessible for a mag drill so after starting one the drill has put the last whuppin on me that I am going to take for this project, so went and bought a 1" annular cutter for the mag drill.
This poses another question. I had already started 2 of the holes one is 5/8" and the other is somewhere between that and 3/4" ( when I had my last whuppin) lol. If I just center the cutter over the holes, will I be able to get the plug out of the cutter.
Why does the 3/4 hang so bad, would I be better off not using the 5/8 first?
It is an old reamer and extra long, maybe I am just letting it get a little crooked?
Am I trying to take too much of a bite with it.
The 5/8 can be a handful, but is manageable.
Should I be putting less pressure on them, they don't seem to cut if I do?