spec for 210 Rcbs mold? Anyone

[GLynn41]

I am hunting for a mold for my Taurus Tracker-- I remember this mold had a short crimp to meplat length--I have been making my own .41 Special hulls and I know i could get some .41 hulls but would prefer to just use the normal hull -- i found one for sale BTW

[Guesser]

I use the Lyman/Ideal 41028 and the Lyman 410610 moulds for my Taurus Tracker. They both finish at 215+/- when sized and checked as in the 410610. Both moulds are discontinued as of now but NOE has copies.

[GLynn41]

thank you -- I had a .41028 and was dummmmm enough to let it go
There is a .410610 on EBay now-- a .41028 shows once in a while
I have been just cutting brass down and may still
reason why i asked about the RCBS 210 SWC is there is one for sale on Ebay
I have several molds but all are too long with out a cut down

[Golfswithwolves]

Mr. GLynn41- I have one of the RCBS .41 210 grain SWC molds. If what you are interested in knowing is the distance from the end of the crimp groove to the meplat (the distance the bullet would stick out of the brass case), I measure this as about .323". Subject to my ability to read my dial caliper. I hope this helps, GWW.