Titan ReloadingInline FabricationStainLess Steel MediaADvertise here
MidSouth Shooters SupplyLee PrecisionRotoMetals2Graf & Sons

Page 2 of 2 FirstFirst 12
Results 21 to 22 of 22

Thread: Pneumatic Swage Press

  1. #21
    got my new tandem air cylinder in my press and got it all set up the way i want it now.. this is the core seating operation in production speed.. https://www.youtube.com/watch?v=fRZ8bRfXbXM i can make 100 bullets of .308 in a little over an hour without too much trouble, and that includes core seating, trimming the jackets, and point forming..

    i do mine a little different than the other swage setups in that i seat my cores b4 i trim the jackets. i found out that if you trim the jackets first with a thinner jacket that the jacket squishes just a little and when you seat the core it stretches back out and you get inconsistent jacket lengths.. seating the core first ensures there is no squish factor and they all end up being pretty much the same length.. this is 30cal core seating at regulated 60psi air pressure. the setup will withstand 150psi so this is no where near max for the press..

  2. #22
    Boolit Master
    Join Date
    Mar 2016
    Hey that's pretty slick!

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check