I see where Elvis Ammo has posted a new video about not baking bullets at as high a temp. If I heard him right it was around 250 F. And he decreased the time also to 16 minutes. He is doing this to try to keep his bhn up. Says he water drops after casting but not after powder coating. You will just have to watch it. This got me to thinking and I was looking at some of the pdf's on the prismatic site. They recommended coating the bullets,put them in a preheated oven at 400f and bake for 10 to 12 minutes. I guess this is from the time they go in,it didn't say anything about flowout. Has anybody tried this? That maybe long enough for what we are doing.