My favorite rifle to shoot is my Lee Navy 6mm. It is just a hoot to shoot out to about 200+ yards.
I use .22 swift brass which is about 4mm short. But it works well.
It slugs to .243.
I started shooting .243 (dreaded j-bullets)
I got a RCBS .243 mold. Which drops at .243.
Started using white label. Nice but the bullets are sticky and get covered in dust.
So I began to powder coat. After coating the bullets are .248
Should I resize? and to what diameter. Lee makes a .243 sizing die. Size after pc-ing?
Seeking advice.
Thanks in Advance