Has anyone else experienced off center flash holes in primer pockets in "Perfecta" brand fired .45 Auto. Brass Cases? I have had some flash holes off center enough to bend decapping pins when resizing and depriming the .45 Auto. Brass Cases. Remedy so far is to "go slow" and "feel" the recapping pin hit the inside of the case head and stop before enough pressure is applied to damage the decapping pin. It happens sooner than in a normal "resizing and decapping stroke", where the decapping pin goes into the flash hole and then engages the primer anvil, so there is some "warning". I have never had this happen before.