Just got a NOE 4160-405RF hollow point mold. Tried it out today and what a job I had. Like all NOE alum. molds I have it likes hot. With 700 degree alloy I started to get nice boolits. Got to looking at the hollow point and about half were not formed correctly. Too much meat on one side of the hole. My fault. I was dropping the boolit to soon and the HP pin was deforming the hole ?
Now I'm turning out good boolits but not near as many as a regular flat nose . I guess I won't be casting a big pile in a casting session anymore. Quality instead of quantity ?
By the way. This is my first HP mold.