On the Encore and Contender 10" 12" and 14" which powders should give the best results in accuracy and velocity in general? Thinking 35rem,44mag, 357max .
Thanks Aaron
Starting with 14" .35rem
On the Encore and Contender 10" 12" and 14" which powders should give the best results in accuracy and velocity in general? Thinking 35rem,44mag, 357max .
Thanks Aaron
Starting with 14" .35rem
joatmon -
Howdy !
IMHO - Give WW296/H110 a try. I used it w/o a filler for .357Mag loads in an 1894SC. Shot great !
I also used it in a .357Max H & R SB2 Ultra Rifle.
WW296 could not be topped on accuracy, for loads shot in my custom 22" 1-16 SS barreled bolt rifle; chambered in
.357AutoMag ( but using a .358" cal barrel ). I did use " Pufflon " filler w/ these loads.
14.5gr WW296 is my go-to load for .357MAg in 4, 5, and 6" "N"-frames.
My point: WW296 gave great accuracy and good vel's in .357" - .358" caliber barrels from 4" - 22".
I'll try to send some pics.
Semi-circular group was shot w/ my custom 4" heavy-barreled .357Mag "N".
The one ragged hole group was shot @ 100yd w/ the AutoMag " carbine ".
With regards,
357Mag
Thanks, I do have a lot of that I could use! I think I was over thinking the shorter barrel thing a bit.
Thanks Aaron
joatmon -
Howdy !
Forgot to mention....
With WW296, you'll need to keep charges " up there "... more towards upper-end of allowable charge; and away from minimal charges.
IMR4227 load info can give an idea of where upper charge limits for WW296 might be
With regards,
357Mag
Aaron -
Pics attached....
Yellow/green target is the 5-shot 50yd group mentioned in PM.
Second group pictured is 5-shot 100yd group. I held off to compensate for windage on the last 2 shots, based
on what I thought the windflag was showing me. Aacck .... both shots went wide of the core 3-shot group !
This XLR can shoot !
Regards,
357Mag
Boy, that one does group well!
Izzy
Howdy !
I'm trying to send some pics
The cream and black bullseye shows a group I shot @ 100 w/ the AutoMag. You'll note a smaller cal hole lower on the target. That hole was there from a previous range cession w/ a different gun; and I re-used the target paper to check out the AutoMag.
Barrel pic shows muzzle end of the AutoMag barrel.
M-336 XLR barrel clamp seen in another pic. I cast it in-place using " casting resin "/
Regards,
357Mag
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |