Noe moulds for 8mm mauser and 6.5x55?

[olereb]

I was hoping some of y'all could recommend a couple good moulds from Noe for the 8mm mauser and the 6.5x55,these would be used for target and possibly for the occasional deer. I would prefer to go with pb over gc but will go gc if needed. I have a ample supply of Unique,2400,reloader 7 and 30-31 which I'll be experimenting with. The rifles used are yugo m48's and a husqvarna m38. Thanks alot for any recommendations.

[Hamish]

IMHO, this is the primary NOE design I would consider for deer hunting having enough meplat. If you plan to limit your self to plain base velocities, judge your max lethal range accordingly.

[hc18flyer]

I have both the NOE 326471fn and the 325365sp in gas check. But my best hunting bullet is an Accurate 33-205T. My Yugo M48 has a big throat and the bore riding design shoots very well. Have you looked at the Group Buy Mihec has for 8mm bullets? hc18flyer

[JMax]

Because 6.5 X 55 Swede rifles have 1 in 7.5" rate of twist barrels limiting cast bullet velocities and still maintain accuracy at 100 yards to under about 1400 ft/sec. I can push my 314-202 bullets to 1900 ft/sec with 1" groups out of my scoped 03 (1 in 10" rate of twist) and that should be more than adequate for deer.

[Calamity Jake]

I have NOE's version of Lymans 323471 and no 8MM to shoot it in.
So it's for sale if you want it.