Suppressor Help - Glock

[Dutchninja]

For the life of me i can not get this gun to cycle suppressed. Anyone have any ideas?


Glock 22 Gen3 with LW 9mm conversion barrel
*Functions fine with all ammo tested below unsuppressed. no FTE or FTF. The 9mm barrel has at least 500+ rounds through it. The Glock is a police trade in which has seen some rounds as well but shows no other issues / problems.

*Liberty Cosmic can (YES I HAVE THE BOOSTER INSTALLED CORRECTLY MOVES FREELY) - FTE with everything below. I have tried both the standard Glock weight recoil spring and a reduced 11 lbs spring with all ammo below.
* Commercial +P 9mm (brass)
* Commercial 115g standard (brass)
* Commercial 124g standard (brass)
* Commercial 147g "suppressed" (brass)
* Reloaded 150g with several powders
* Reloaded 115g supers, several different powders

I can see the case come half way out and either jam or the slide goes back into battery. nothing cycles.

I take the same ammo above, same can on a G19 with a LW barrel and everything works with more gas, less slide / barrel weight. I put my hybrid on the G22, knowing it wouldn't likely work cause that's even heavier that the cosmic, but the same occurs.

Thoughts????

[Reddirt62]

+P failed to cycle? Hummm...i am having issues as well but I have only tried my reloads and mine is a monster can....silencerco hybrid.

Sent from my SM-N920V using Tapatalk

[HATCH]

Get a 9mm recoil spring

[Dutchninja]

HATHC - See above - I already used a lower power 11 lbs spring with no luck. G22 and G17 factory springs are both 17lbs. 17lbs does not work either. I got lower than 11lbs then i'm going to have issues on the other end.

Reddirt - check post above. i tried my hybrid, and before i had even pulled the trigger, assumed that the increase weight between the cosmic and hybrid, it wouldn't work.

Other thoughts?