I just got a 147 grain NG mold from MP-Molds.
It ..or I.. seem to have an alignment problem, making boolits uneven.
The back pin have become a bit submerged, and I wonder if that is the culprit - or there perhaps is multiple things I am unaware of, being new to casting. I have two lee molds that doesn't have problems.
I don't hit the mold, or abuse it. It has cast boolits like this from the start.
Is it possible to punch the pin back out to align without damage to the mold?
Is it thightning of sprue plate - or other things?
Thanks in advance for your two cents on this.