I have the following GC material to PIF.
I have sold most of my Gas makers, so I no longer need this stuff.
All material to go, this is one PIF.
9 sheets of .011 alum (amerimax I believe?) aproximately 6" x 9" each.
2 sheets of .010 Copper, 5" x 8"
12 strips of .016 copper, 1/2" x 6"
All 'suggested' PIF rules apply (read stickies). The First member to post "I'll take it", gets it...please send PM afterward with USA shipping address.
(this is the first of two PIFs I'm making, in thanks to ZmanWakeForrest, Retread, & BrassMagnet for the shell holders)