New to me P64 is my new project... Have slugged barrel,obtained new brass and cut 9x19 down to 9x18... ordered new sizing die, cast some 95gr using Lee 365 95R mould... assembled some dummy rounds. Have experienced feeding issues when set to OAL @.982 then kept backing down....problem goes away completely @ .950... I see some loads listed in Lee Manual @ .365.... anyone have experience running this bullet in a P64? I haven't even tried to polish feed ramp yet... and haven't really fired the assembled rounds on the range... just trying to hand cycle to see how they will function... any help is greatly appreciated.... thanks for looking