The Mihec 401-200 is exactly what you describe, 200gr as a wide flat nose, and either 180 or 190gr depending which hollow point pin you use, deep or shallow. The shallow pin is for 10mm and minimal expansion, and the deep is for 40 S&W and/or maximum expansion. This was an Oreo group buy a few years ago, you might find someone willing to sell theirs or maybe Mihec will do another run of them. It is a great mold.
You could order this design in a flat nose from Mountain Molds, and then have it hollow pointed. I have done that for people, but am really busy right now and couldn't get it done quickly, it would be at least 6-8 weeks.
This is the Mihec mold cast in air cooled wheelweight with the shallow pin. Short barrel 10mm result on the left, middle two are longslide 10mm results.
Another view, group of 5 in the lower left.
If you search the group buy section, you might be able to find the thread. This is from that thread as we were discussing the design, some of the dimensions changed (especially the hollow point, for the better) but you get the idea: