I have a problem with a nei mehanite bullet mold as it produces a finned boolit. There is nothing on the mold faces .when I'm casting, but I can see the space between the blocks when held up to the light. It appears that the mold is resting on the base of the mold pins but I am not sure. Can I drive out the mold pins stone the mold faces perfectly flat and drive back the mold pins for a cure? I had the mold for quite a while but never had an opportunity to use it until recently so I feel like I'd be wrong letting Joel at Nei have it for doing a bad job now. I appreciate any and all solutions you can offer. It is a custom one of kind odd ball caliber and not easily replaced because of the extremely large boolit.
Thank you
RR