Flying purple people eater's

[Pete P]

But seriously this is Eastwood's translucent grape, one coating, shake and bake. This covered much better than Harbor freight's red. I am lucky enough to have an Eastwood store about 45 minutes from my house. I was in the area so I stopped in to pick up some powder. It was my first time there. On their display were samples pieces that have been coated. I went in to get one color and walked out with another. With all the colors that I've seen I think this is going to be addictive. I did try the Hi-Tek coating but because my lead is a little too soft and the diameter is off too I experienced severe leading. When I tried Harbor freight's red powder coating I had zero leading.

[LeadPoisonTX]

I did try the Hi-Tek coating but because my lead is a little too soft and the diameter is off too I experienced severe leading. When I tried Harbor freight's red powder coating I had zero leading.

Those are some nice looking Boolits - cool color. Which color Hi-Tek did you use, and how did you apply it? I have used Gold, Red Copper, Brick Red, Zombie Green, Gun Metal, and Black, all applied with acetone. I obtained good results with my soft lead and non-sized projectiles. I did coat them 4 times.

[Peregrine]

Those turned out really nice looking!

[w5pv]

Watch for etching around the cylinder and chamber,I experienced etching at these spots and returned to Ben's Red,no etching or nothing to clean in the chamber and bore.

[sparky45]

A little BLL on those and they practically run out the bore by themselves.

[Drew P]

Watch for etching around the cylinder and chamber,I experienced etching at these spots and returned to Ben's Red,no etching or nothing to clean in the chamber and bore.

Etching?