Dies that work in the Dillon 650?

[randyrat]

Who's dies work in the Dillon 650 XL In the 9MM ?

[sparky45]

Same size,same thread. One of the few things that the industry can agree on. I use Lee dies in an RCBS press, or my Dillon 650.

[dragon813gt]

They all should.

[bosterr]

They all work but Dillon's seat dies come apart with a clip so you can clean old lube out without changing your settings.

[NoAngel]

So do Hornady.

[VHoward]

On some Lee dies, you might have to install the lock ring on the bottom of the tool head as the threads don't go far enough up.

[DocSavage]

All the major die manufacturers will work with exception of the dies for Dillon's Square Deal presss.

[rockrat]

I use teflon tape on the top of the die threads with Lee dies used on my Dillons, to hold them in place

[54bore]

They all should.

What dragon813gt said ^^

[David2011]

The Dillon sizing and decapping die has a spring loaded decapping pin that pops the primer off of the decapping pin. Helps prevent pulling spent primers back into the primer pocket. They cost a little more than RCBS or other major brands but I have several sets of Dillon dies and have never regretted getting them.

[RMII]

Yep - the beauty of most dies is the interchangeably, at the one's I have.

[Handloader109]

THe Dillon work best in 9mm with the 650xl, but the others will also.

[country gent]

I have radioused the ends of my decapping pins so spent primers don't grab or lock on the pins corners. Helps a lot with them releasing when pushed out.

[derek45]

DILLON, LEE, REDDING, etc

Like others, I've had to put the locknut under the tool head on some LEE dies

Dillon lockouts work best