I have a lyman 450 that is my main luber sizer and has worked great in the past. Haven't used in quite a while since I have been working of a generous supply of lubed and sized boolits. Recently decided I needed a supply of fat 30 caliber boolits. I have a supply of 311284s and 311299s that dropped at about 0.314-15 . Tried to size and lube with a RCBS 0.314 di. Sized fine but no lube. This di has one row of holes and no lube goes on the boolit. I did replace the RCBS di with a Lyman 0.313 dia di and everything works fine. I am using Lar's Carnuba Red lube. I would like to use the RCBS di for my SMLE but sizing then smearing lube on the boolit then running through the di for a second is not a very fast way to create boolits even for a bolt action rifle. Anyone have any idea what I AM DOING WRONG OR HOW TO MAKE THE SINGLE ROW DI WORK. I know I have other RCBS dies and I think they have a single row of holes. They have worked great and I haven't had this problem before. Any advice would be greatly appreciated. I just won't try it until after this awful record heat breaks. Thank you Duckiller