Hope everyone had a Merry Christmas! Question in regard to sizing powder coat and/or Hy-Tek bullets. Must be doing something wrong....previous to this used a RCBS lubri-sizer with no issues or effort (Randy's Lube). At the very front end of starting to PC and Hy-tek the same bullets as before (range lead...point is same hardness, same mold). Bought a new NOE push-thru sizing die for Xmas. My 9mm bullets drop at .356, with PC (Smoke's) or Hy-Tek (Bayou) running around .357. Sizing back to .356, but for the life of me I can't push 'em through! Ton of resistance....have used some lube (Hornady spray), cleaned/polished the interior surface of the die...still much tougher than it should be. Ideas, suggestions? Both coatings are coming out beautifully, passing all the 'tests,' cooking at the 390-400 degree range. At a bit of a loss, probably something simple I'm missing. Nothing like I see on the youtube videos! Any help please...