This thread follows on from the one in the Group buy Forum
here:http://castboolits.gunloads.com/showthread.php?t=25795
I can confirm that the mould is a beauty its right up there with the best bespoke moulds.
Here it is fitted to a pair of Ricks quality handles.
The mould halves fit together seamlessly with just the right amount of slight resistance as they finally close.
The sprue plate was little tight for my taste but is easily adjusted, as can be seen from the photographs it is plenty thick to allow alloy pull into the mould on cooling.
The mould was cleaned with isopropyl alcohol and it was ready to cast.