I just purchased a sporterized Eddystone with no iron sights and Weaver bases on the ground receiver.
This is my first time for this type of scope mounting.
I measured the distance from the top of the Weaver mounts to the top of barrel where the scope bell will impinge. I did this with a straight edge on the upper ledge of the bases extending over the chamber area and using a caliper.
This base height is .362" above the top of barrel at chamber area.
The scope bell is 2.00" (44mm obj)
The scope tube is 1.00"
I think that leaves .138" or more that I need the rings to raise the scope.
I have looked at the various calculators online and searched here, but I guess I am just too dense to see the pattern.
How do I take that value and translate into low, med. high rings.
Thank you for the hand holding.