Ammohead used to make these but he is moving and won't be up and running for a goodly while
{"Rod,
I made myself an adapter that fits in my rcbs rockchucker that will take any lyman/rcbs sizing die and use it as a pass thru sizer. I make a pusher for each diameter that fits in the shell holder slot and the die goes upside down into the bottom of the adapter. Put the boolit on the pusher and raise the press till it comes out the top (bottom) of the die, viola. Works with any size die you have.
Feel free to pm me."}
From what I could figure out this is has threads that will go into a press and the center will hold a Lyman H&I die (set screw?). The pushrod is similar to the Lee push through sizers but longer so a bullet will be pushed completely through the die/holder in one pass.
any suggestions?
thanks