there is a rerun of this bullet mold (active) right now on the noe forums.
http://noebulletmolds.com/smf/index....ic,1891.0.html
there is a rerun of this bullet mold (active) right now on the noe forums.
http://noebulletmolds.com/smf/index....ic,1891.0.html
Last edited by cornmastah; 01-31-2017 at 05:36 PM.
Signed up!
Continuing the thread hijack, n10sivern have you considered the 360-280-RN? I bought one in RG4 (HP) and milled off the gas check shank to make it PB and about 20 grains lighter, for subsonic and full steam 358 win loads. I'm also thinking about getting a set of blank pins to make a wider HP for the subsonic loads.
Regards,
gs
I apologize for the thread hijack. As for the 280, I have not considered it but thanks. Now I will.
Hijack away! This mould is already being run now. In truth all his moulds are top notch!
Have y'all loaded the 358 win subsonic? Should I just start with 10gr of unique and load down from there?
I put in my order .... Al Nelson is getting rich...and a good portion was donated by myself
Do, or do not.
There is no try.
Yoda
n10sivern, that's a popular place to start. This thread might help, if you haven't already found it in your searches:
http://castboolits.gunloads.com/arch...p/t-39923.html
Just got a message back from Al. He is changing the pin for us
Sweet!!!
Awesome! Those will be seriously wicked on expansion!
I will upload the new drawing in the group buy once I get them from Al. I might need to get an RG4 with the new pins for myself now... ha ha.
Will this bullet work well in PMAGs?
Probably not but should in metal mags.
Swede was worried about the new wider hp pins making it too thin at the tip of the bullet, so he is going to include both sets of pins at no additional charge. That way, it should be a win-win for everyone. If you like the older style pins, you will have them--and if you wanted the newer wider ones, you will have those too.
And in response to aaholland, I use this bullet with pmags in my sbr and it has fed fine in my gun, but every gun is different.
That's awesome. These can't get made fast enough. I have 2000 cases waiting to be loaded and 900 pounds of lead waiting to be cast
Just curious, what would be a realistic ETA for these? I know NOE isn't know for being the fastest making molds.
The larger pins are no problem. Working on a load for it right now. Well, 2 loads. My SBR that is 8.5" takes a different load than the 16" does to keep it subsonic.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |