Can i get some thoughts on taking some LC brass from start to finish for a round to hunt with. This is what i have done so what did i miss or over do.
weighted cases culled out over and unders for a even batch
Deprimed brass and removed crimp
wet tumbled with SS pins
loaded with trailboss and cast bullet to fire form
deprimed wet tumbled again
neck sized only and trimmed then walnut tumbled
primed and loaded 5 for testing or working up a load.
Have not deburred flash hole or annealed necks
yes i know i clean the brass alot but i did not want any problems with dirt oil and shiny brass is happy brass lol
I checked to see where the bullet engauges the lands and am starting at the bottom of the load data, What i can not remember off the top of my head is what percent do you decrease your load for military brass since the volume for the power is less due to the thickness of the brass.
Do i need to ream the necks do i need to anneal ? and i have been told fire forming with trail boss was a waste of my time but it was fun.