I would go with a gas check mold. I would think better for all around use.
I run a 145gr PB to 2100 with accuracy in 1:10 BO. Can't get there with 1:7. NOT coating the base works best for me. I can't guarantee a good flat base when PCd as I stand them on the base to cook. Cooked laying down I get sags when the stuff flows - not good for accuracy.
Whatever!
this is a case of maybe.
maybe it'll fit, and maybe you can push it to 1400 or so.
you'll maybe have to size the nose if you coat it.
personally I'd go another route, but I like simple.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |