Loaded some 45-110 for first timemy load

[69daytona]

After collecting all the fun stuff to cast load and wrap these 45-110s I got busy today.
after 2 hours using Kenny Wasserburgers load setup I got 60 rounds loaded and ready to go.
this is a lot more involving than making high power match ammo.
if the rcbs powder measure was adjustable enough to throw a close to accurate amount of powder that would save a lot of time.
My load today is 105gr of goex 1F with Kenny's wad stack, .06 plastic, .06 wool and .03 fiber with .340 compression with baco 535gr money nose Paper patched.
with 8lb tracing paper wrapped boolits come out .451. A loaded round coal is 4.80"
and is a snug fit in the bore, enough to keep the boolit and pull the case out with a thumb press boolit fit in case. No tearing of paper after I knocked out the test round.
hope to get out to the range to try them next weekend.
anyone know of a cartridge case that will store these nose up without buying the nice but expensive walnut cartridge boxes on some of the BPCR sites?
Thank to all here and Shiloh site for all the information and help.

[Keith Andersen]

Good luck with that wad stack.

[Don McDowell]

Don't forget to get all the stuff together for wiping between shots.

[Gunlaker]

J&J Products ammo boxes will hold those rounds base down. They are much higher quality than the MTM boxes. You will need the biggest one.

Chris.

[69daytona]

Thanks guys, I have a couple of deleting rods from Arizona shooters along with their patches, bought a rubber wiping plug to save a few patches, will see how that works.
was reading Dan Ts posts on Shiloh site so starting with 16-1.
will check out J&J for some boxes.

[sharpsguy]

Good luck. That's gonna be an eye opener.