.380 ACP NOE/Ranch Dog TL 100grn FN

[Bigslug]

We just went active with this buy on the NOE forum - SIGN UP THERE: http://noebulletmolds.com/smf/index....ic,1326.0.html

In the discussion thread on which we generated initial interest, Ranch Dog outlined his testing process - slaughtering 150# pigs with thoracic shots. Claims rapid expiration of the critter with penetration to the cavity wall on the far side. Should fuel all our LCP's, PPK's, 1908's, etc... quite nicely!

Solid
and hollow point

Prices according to Swede:

"We will be running 2 cavity, 2 cavity Brass, 3 cavity, 4 cavity, 4 cavity Brass, 5 cavity, RG2 cavity, RG2 cavity Brass and RG4 cavity, RG4 cavity Brass. Plain base only.

We offer Blank RG pins on our website for you that like to make your own.
Top punch, wrenches and sprue lube are extras now if you want them

Prices will be our standard website prices ( www.noebulletmoulds.com )
2 cavity $79.00
2 cavity Brass $101.00
4 cavity $92.00
4 cavity Brass $114.00
5 cavity $99.00
RG2 cavity $103.00
RG2 cavity Brass $125.00
RG4 cavity $133.00
RG4 cavity Brass $155.00

Lyman/RCBS style Top Punch $5.00
Saeco style Top Punch $7.50
Mould Wrenches / Sprue Lube $2.50
RG2 blank pin set $4.50
RG4 blank pin set $9.00

Will run this as soon as we get 10 signed up and we get the tooling in.
Will have them listed on our website as a inventory item as soon as we have them ran
So you can use Pay-Pal, Credit Card or Check / Money order
Post a "I want" and receive a 15% discount off the website
We will PM a discount code for you to use at check out"

[Bigslug]

We're almost there on this one. Just need one more player!

[Bigslug]

Just went to the last call section! WOOOOOOO!

http://noebulletmolds.com/smf/index....ic,1326.0.html

[silverjay]

Got the email today for the 0.314 version!

[Bigslug]

Not sure how to move from "ACTIVE" to "CLOSED", but I got both of the little lovelies in the mailbox today. .32 on top, .380 below.

Warming up in the oven on their first heat cycle in preparation of the maiden pouring tomorrow.

Thanks for playing everybody!

[Rattlesnake Charlie]

I have this mold in aluminum 6-cavity. I bought it directly from Ranch Dog when he was still selling them. It is a great boolit for the .380 ACP. I coat them with JPW. No other lube. No sizing. Shoots great in all three of my pistols.

[fatelvis]

In the discussion thread on which we generated initial interest, Ranch Dog outlined his testing process - slaughtering 150# pigs with thoracic shots. Claims rapid expiration of the critter with penetration to the cavity wall on the far side.

Was he using Hps or solids?