I have a new Star lube/sizer with bullet feeder was curious if there is a template available somewhere to help with drilling the holes (the 3 for the star are easy).
Thanks,
oteroman
I have a new Star lube/sizer with bullet feeder was curious if there is a template available somewhere to help with drilling the holes (the 3 for the star are easy).
Thanks,
oteroman
I presume you want the hole layout for both the Star, and the Bullet Feeder together as an assembly?
The Bullet Feeder you are using would probably help a little.
Bob
I am using the Standard bullet feeder. I have the same Star mounted on a 1/2" plate and heater installed with a thermostat from an electric hot water heater. Tested and works great...I do need to drill and tap a hole for the bullet feeder but that is an easy task at this point thanks much.
My phone changed my typing LOL.
I have a Star bullet feeder.
check out this thread post #2 gives some dimensions don't know if there to center of hole or edge but maybe it will help.
http://castboolits.gunloads.com/show...ase-Dimensions
My Straight Shooters thread:
http://castboolits.gunloads.com/show...raight-Shooter
spstocksandgrips.com
Texan Loadmaster Model T, Lyman All American Turret, Forster Co-Ax,
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |