Mystery Swaging Dies?

[.30harris]

Has anyone ever seen a set like this before?
It seems to be a core seating die in .308, a .308 point former, and a slightly larger than .308 (.312 maybe?) point former. All 3 dies thread nicely into the die holder.
The die holder seems to fit in my Hollywood senior tool, but obviously, the nut at the bottom doesn't reach the bottom of the Hollywood's shellholder block.
I'm not sure if the punch for the core seat die is correct- I found these in a large lot of parts I'm still organizing. I'll get more pictures into this thread as time goes on.
Thanks for your help!



Core Seat


Forming die threaded into die holder

[Pressman]

the die holder shank looks like it fits the Easton Big Giant press. Measurements would tell for certain. I am not aware that Easton made swaging dies. But then I cannot imagine swaging on a Big Giant either.

Ken

[salpal48]

The shank does Resemble Easton Except . Eason Big Giant shell holder does Not have that Forward shoulder it is One size with the entire Length
Sal

[.30harris]

Thanks! That makes sense - I did find some dies marked 'AA EASTON'. I think some were typical reloading dies, others were for case forming. I'll put some more pictures up soon.

[Pressman]

Sal, I have Big Giant # C196 and that is the profile of the shellholder in that press. My other Big Giant has been modified for RCBS shellholders.

Ken

[salpal48]

Ken, You are Right. I just checked My easton shell holders and That is the profile
Sal