How would I go about shortening the ogive on the CH4D 101 series 40 cal dies? Im not super crazy about the current profile of the die. I tried adjusting the hollow point pin down, and it dkes give me sort of the results I'm wanting. But the pins shoulders get lodged inside the jacket when compressing. To be clear, I'm using 9mm cases for jackets and have been using the shoulder on the hollow point pin to compress the jacket when swaging.
So would I be good to go by turning a new one piece, instead of the two piece CH4D supplies, hollow point pin with a slightly larger shoulder near the tip? If my thoughts on this are all wrong, school me!