So I fell into a old star sizer (one of the old timers at the club said 25 bucks and my wallet was out before he finished talking).Im ordering some dies from lathe smith and air assist from kyle632. Just need a heater. I drilled and tapped the lyman heater for my old 45 but I dont have temp control, just unplug when lube starts to get too thin. Could I do the same with the star? From what I read here the star is a fine balancing act of temp and pressure. The lube I use in the 45 is JAKES PURPLE from flee bay and have had good luck with it. Kinda need a goodbit of heat to get it flowing.