RCBS Mold Handle Pin Retaining Screw

[Thomas Traddles]

#$%^$@! I dropped the mold handle pin retaining screw on one of my molds and have lost it. I am wondering where I might find another one of these. Anyone have an idea? Thanks.

[SteveS]

I'm sure RCBS could send you one.

[runfiverun]

your neighbors drive line should have about 40-50 of them.
needle bearing.

[MT Gianni]

Screw can be found at almost any hardware store. Allen head but I don't remember the screw size and pitch. The retaining pin as mentioned is an old needle bearing. If it is missing you could cut a drill bit of similar size or call RCBS.

[bhn22]

It is simply a hardened pin, held in place by an allen head screw. The possibilities for replacement are endless. This is probably the most practical handle retaining system out there, and I usually replace my H&G mould pins with this because the H&G style get fragile and break over time.

[Hardcast416taylor]

RCBS 1-800-533-5000

Robert

[Thomas Traddles]

Thanks, all. I've not lost the pin, just the screw.

[MT Chambers]

Common size set screw from Ace, i don't remember the size but take one side of blocks with you, dont get a setscrew that is too long.

[Red River Rick]

.............. i don't remember the size .............

#10 x 32 TPI

RRR