I have honady ans gator bas check and on 8 mm mauser cas bullet with Lee mold
They dont hold solid,their not eigh enough.any info on size to make a check
Maker with eigher gas check
Thanks
I have honady ans gator bas check and on 8 mm mauser cas bullet with Lee mold
They dont hold solid,their not eigh enough.any info on size to make a check
Maker with eigher gas check
Thanks
I have no issue with the GC on that boolit. Measure your gascheck check shank diameter on the cast boolits & get back to us
Something isn't right. You are using 8mm / .32 cal gas checks correct? I don't use gator on those but I do use hornady and after there go thru my sizing die they can't be pulled off
" Associate with men of good quality, if you esteem your own reputation: for it is better to be alone than in bad company. " George Washington
Try running your alloy a little hotter and be sure your mould is up to Temp., pour a LARGE sprue puddle and check for good base fill-out.
Larry
I mesure seize gas check 30 is .080 eigh ans 32 is .074 eigh .they use the same
Disc size for Both calibre.
And yes my cast are good cast
OK,just dix a check maker ,it make a gas check ,080 eigh.
And i cant removed it by hand.now just have to shoot some
Run this through spellchecker then maybe some will respond, sounds like the mold is dropping too narrow at the base.
He is saying the height of the gas check isn't high enough. That they are too shallow to get a grip on the bullet side . If the bullet base isn't filled out enough it may be too rounded to work well with this.
n.h.schmidt
my new gas check hold good,and the rod on the lee puch sizer whas worn to .289 so i machine one of 324.
Sorry,
But there is no way that a push rod in an 8 mm Lee Sizer die can wear to .289".
Someone may have accidentially mixed a push rod from a die that was smaller than 8 mm.
Wear- - - - No , not by wear.
A small drop of super glue on the base of the boolit or inside the check will hold them in place. Do it before you size and press on the check.
That's Canadian eigh!
OK ( eigh ) , I guess I'm learning...........
Last edited by Ben; 02-28-2015 at 08:43 PM.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |