Not sure which area is best to post the question, so I'm putting it here (this will also help me get to my 25 posts so I post a trade message to see if anyone is interested in trading a Lyman 410663 for a Lyman 410678...).
I just signed up for a 45acp bullet mould group buy. This will be a 6C mould. I've always had bad luck when casting in multiple cavity moulds. I'm accustomed to large bore BPCR type slugs and use a dutch oven pot and ladle.
What technique do you use to get the lead in all those holes and get a good boolit out of each hole???? I'm almost wondering if it's easier to bottom pour into pistol moulds. I've had good success holding the mould up tight against the pot spout. How well does this word with a 6C mould. Are there threads on this in the archives?
Thanks for the help.