Yesterday no work, because the carpenters did not have the roof ready on the shed they were building. so I finished ducting in my ventilation hood over my casting pot and, tested it by heating up the pot and fluxing it a couple times, worked good. Photos on posts in this thread on page 427. poured a handful of rcbs 38-158-swc gas checked. then proceeded to clean 4 out of five of my handguns. Did not do five because it’s just my 22 buck mark and did not feel it nessary. Then felt it was as good of time as any to slug the bores of my pistols 2 9mm 1 44mag 1 44-40. So grabbed my torch and cerrosafe and prepped and poured each one setting timers to catch them while they were expanding to actual size. The two 9mms measured .356 despite being 57 years apart in age. The 44 mag is .431 and 44-40 is 429.
Ducting pic